If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
SileNceR, Messenger of the Dark and the Night. To post quality, or not to post at all, THAT is the Question - Never again ask what can my post count do for me besides increasing my ego, but instead ask what can I do to help someone else!
Overclockers Melbourne (http://www.ocmelbourne.com).
As some of ya may know my old K6-3+ server finally decided it would refuse to work till it had a rebuild so here it is runnin' on the workshelf ( :laugh: ) while I write this post with it. :)
Yep an old AT board there but I forgot to take the before shots of the case but here it is after a clean up and replaced the front 80mm intake fan with a 120mm one plus filtered all 3 intake fans.
I got them from Jaycar which is an Australian/N.Z. electronics store and the 80mm cost $4.75aus with the 120mm at $4.95. ;)
<center>:cheers:</center>
Thats a sweet case wiggo!!! Looks like you shouldnt have any trouble keepin' your good ol' K6-3 properly chilled... LOL. Did they even make server boards for the K6-3 with RAID for server setups?
Sadly no they didn't make any such boards and the K6-2/3/+ are all MP capable as well. :(
As for keepin' the K6-3+ 450MHz cool well it's a bit of a job while it's tickin' over at 560MHz under full load 24/7. :D
<center>:cheers:</center>
Comment