If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
IRST 11.1.0.1413
Realteck 2.46
Jmicron 1.07.28
Marvell Bios Version 1.0.0.1033 / Firmware 2.2.0.1125
After flash is complete, shut down fully and switch off PSU, wait one minute and clear CMOS. Then turn on, boot to BIOS and load optimized and save/apply/reboot back to the BIOS. Once in the BIOS again set AHCI settings and Marvell Firmware mode to "Force", then save/apply/reboot and let it load through to windows, before that happens Marvell Firmware will update and board will reboot.* X58AUD5MOD_4_12_12_Complete.ff3.rar
Main Rig Gigabyte z87x-OC
Haswell i7 4770k - 4.7Ghz @ 1.330v LLC Extreme (L310B492)
G.Skill F3-1700CL9D-8GBXM DDR3-2133mhz 9-11-10-28 1.65v @ 2800mhz 12-14-14-35 1.7v
Samsung Green 8GB 2x4GB MV-3V4G3D/US DDR3 1.3v 30nn @ 2200Mhz 11-11-11-32 1.60v
Sapphire ATI HD 7970 3GB clocked 1200MHz @ 1.181v.
HiS ATI HD 6950
Samsung 840 Pro 256GB SSD (boot Drive) on Intel sata3 controller port0
Corsair Force GT 120 GB Sata3 SSD on Intel sata3 controller port1
Samsung 320GB HD322GJ 7200 RPM 16M cache on Intel sata3 controller port2
Sony Optiarc DVD-RW AD-7240S on Intel sata3 controller port5
CORSAIR CMPSU-850TX PSU
Swiftech MCP655-B Pump
EK Supremacy Cpu Block
Swiftech Mcres Micro Rev 2 Reservoir
Black Ice GTX Xtreme 360 Radiator
hy
guys i found this nice forum over HWbot
and saw that here are some skilled bios programmer
so i have a question is there a possibility to mod the bios from GA P67a ud7 board (latest bios which supports IVE bridge cpus)
that i can set higher voltage for benching IVE i need to set voltage up to 2,00V
so best will be that there is the possibility to set it up to 2,1V or 2,2V in bios
Comment