If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
@ wazza
I do not remember if auto raised the ioh v or not . As I posted . I had issues at opt def .
I manuelly set all the voltages to default as I usually do after booting the board a few times . So I started with the ioh at 1.1 and right after the os load and testing I went to 1.2 . I was very reluctant to set any voltages high to start with . This was my 1st I7 build . I am also normally pretty conservative with oc'ing until I learn what my parts like . Then as long as I can control the heat .......its cool .
I should add this . I retimmed the board and removed the Gigabyte plates from the heat sinks . There is a 80mm fan blowing on the ioh sink . Temps run between 37 and 43c depending on load . Ambient 25ish .
My vid card is a Fire v5800 . I do alot of 2d stuff and run Auto Cad here and there .
Major props for what you and LSD do here !!!!
In the next few days I'll get my act together with my info and hope to help when I can .
IOH should be fine on auto, 1.3 shouldn't be needed at anytime unless you have tons or memory installed and are pushing 210-220+ Bclk and even then less should be fine.
So your thoughts on "Needing" 1.3 may be skewed by some other setting that is off, making it appear that using less than 1.3 MCH is the issue
Comment