hi, long time watcher, first time poster.
my ga-ep45-ud3p (bios f4->f7->f9 none work, cmos cleared) wont boot my g. skill pc6400 2x2gb (f2-6400cl5d-4gbpq) (passed memtest x24hrs in single channel) ram set in slot 1&3. The computer jsut starts running for ~5 sec and then restarts. It never even posts. if i place the ram is slots 2&4 the computer turns on but never restarts or posts.
if i put the ram in slot 1&2 (single channel) i can boot straight into windows. Also either chip will boot in slot one by itself.
i have tried to increase the ram voltage to 1.8->1.9->2.0->2.1v. I have increased the MCH core 1.1->1.2->1.3. I have also dropped the timings to 6-6-6-18, at 667
I recently tried someone elses PNY RAM with the same results
it must be the board, right? is there something in the bios im missing or was this board DOA?
e7400
ga-ep45-ud3p (1.0)
g. skill pc6400 2x2gb (f2-6400cl5d-4gbpq) (passed memtest x24hrs in single channel - ddr800)
9800gtx
ultra v-series 500w
vista
Bios Settings - See in post below
my ga-ep45-ud3p (bios f4->f7->f9 none work, cmos cleared) wont boot my g. skill pc6400 2x2gb (f2-6400cl5d-4gbpq) (passed memtest x24hrs in single channel) ram set in slot 1&3. The computer jsut starts running for ~5 sec and then restarts. It never even posts. if i place the ram is slots 2&4 the computer turns on but never restarts or posts.
if i put the ram in slot 1&2 (single channel) i can boot straight into windows. Also either chip will boot in slot one by itself.
i have tried to increase the ram voltage to 1.8->1.9->2.0->2.1v. I have increased the MCH core 1.1->1.2->1.3. I have also dropped the timings to 6-6-6-18, at 667
I recently tried someone elses PNY RAM with the same results
it must be the board, right? is there something in the bios im missing or was this board DOA?
e7400
ga-ep45-ud3p (1.0)
g. skill pc6400 2x2gb (f2-6400cl5d-4gbpq) (passed memtest x24hrs in single channel - ddr800)
9800gtx
ultra v-series 500w
vista
Bios Settings - See in post below
Comment