If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
@stasio Do you have anything for x470 aorus gaming 7 wifi? I saw that you shared new beta for g7 but its for wifi50 anniversary edition.
Can you send to my email agesa 1.2.0.0 lastest beta bios for aorus gaming 7 x470 wifi?
Dont know if it will work for normal g7 wifi.
Why did you disable PCI-4 and many other settings that improve performance? (above 4g and BAR support). From what I have read, AMD Ryzen 5000 run hotter than Intel CPU's. Also regarding the phantom load, I noticed that RGB software or other software that can report MB metrics (temps and CPU utilisation), even AMD Adrenalin will consume upto 5% CPU with constant polling.
Its just an clean setup. I tested everything. - disabled above 4g + BAR support. The cpus are custom watercooled. RGB is off. Its not draining cpu power.
There is some kind of problem between the gigabyte mainboard and the graphicscard.
On my system (X570 AORUS ULTRA), the BIOS versions of F32a number one (BIOS date: 01/13/2021) and number three (BIOS date: 01/15/2021) caused problems. Probably because of SAM and the PCIe interface. I had already observed the whole thing with BIOS version F31. If SAM is activated in the above versions, I had problems switching between my two systems on my computer. Restarted the computer from system 1 (NVME Force MP600 PCIe 4.0) in order to start my second system (NVME Samsung PCIe 3.0). The computer boots normally, but there is no image output on the monitor. But you can clearly hear the Windows startup sound. It stays that way until a CMOS reset is carried out! Otherwise nothing more possible. If in BIOS = SAM is deactivated in these versions, the system does not display any image signals on the monitor either, but it can then be "reanimated" by simply switching the computer off and on. Only with BIOS F32a of issue number two (BIOS date: 14.01.2021 = AGESA 1.1.0.0) there are no problems whatsoever on my computer and it seems to run very reliably even with SAM ... The switch between the two PCIe NVME systems also works full satisfaction! Addendum: My GRAKA, the Asus ROG STRIX RX5700XT is also connected to the PCIe 4.0 interface! Perhaps this information can be useful.
@stasio
UEFI feedback: F32a
No errors or crashes.
Boost, good. But have created myself, Powerplan.
The only problem I have had for a long time:
DEL key to get into the BIOS. Does not always work.
AMD 2700X | GIGABYTE AORUS X570 Master | 16 GB GSkill Trident Z DDR4-3600 CL18 | MSI GTX 1080 ti Gaming | Auzentech X-Fi HT HD | WD SN750 500GB | Corsair RM750i | Win 10 Pro
On my system (X570 AORUS ULTRA), the BIOS versions of F32a number one (BIOS date: 01/13/2021) and number three (BIOS date: 01/15/2021) caused problems. Probably because of SAM and the PCIe interface. I had already observed the whole thing with BIOS version F31. If SAM is activated in the above versions, I had problems switching between my two systems on my computer. Restarted the computer from system 1 (NVME Force MP600 PCIe 4.0) in order to start my second system (NVME Samsung PCIe 3.0). The computer boots normally, but there is no image output on the monitor. But you can clearly hear the Windows startup sound. It stays that way until a CMOS reset is carried out! Otherwise nothing more possible. If in BIOS = SAM is deactivated in these versions, the system does not display any image signals on the monitor either, but it can then be "reanimated" by simply switching the computer off and on. Only with BIOS F32a of issue number two (BIOS date: 14.01.2021 = AGESA 1.1.0.0) there are no problems whatsoever on my computer and it seems to run very reliably even with SAM ... The switch between the two PCIe NVME systems also works full satisfaction! Addendum: My GRAKA, the Asus ROG STRIX RX5700XT is also connected to the PCIe 4.0 interface! Perhaps this information can be useful.
Thx for info.
Btw, from where you get F32a...date:01/15/2021 ?
Second....only F32a.....date:01/14/2021 is verified Beta.
Thx for info.
Btw, from where you get F32a...date:01/15/2021 ?
Second....only F32a.....date:01/14/2021 is verified Beta.
Well during my fight with 2 m.2 drives i think i install once this 01/15/2021 , problem is there wa like 3 or 4 different version F32a which is very confusing , personally i use F32a 1/13/2021 atm
stasio
F10 AGESA ComboV2 1.0.8.1 from official support with no Bar/Sam and i got this too: "The computer boots normally, but there is no image output on the monitor" Only CMOS Reset possible.
@stasio:
I downloaded all three F32a BIOS versions here. The only difference is the BIOS date. Only the second version with the date January 14th, 2021 has the ID for AGESA 1.1.0.0 in the BIOS. All others have no other ID.
The third version therefore only bears the date for January 15, 2021.
Unfortunately, I no longer have the third BIOS dated January 15th, 2021 on it. It was the BIOS that came with a hyphen in the name. The BIOS has this date of January 15, 2021.
X570AORUSULTRA.F_32a
All other F32a BIOS versions came without a hyphen in their names.
Unfortunately, I no longer have the third BIOS dated January 15th, 2021 on it. It was the BIOS that came with a hyphen in the name. The BIOS has this date of January 15, 2021.
X570AORUSULTRA.F_32a
All other F32a BIOS versions came without a hyphen in their names.
X570AORUSULTRA.F32a
I renamed every BIOS dated 01/13/2021 to F_32a or F_12a.
There is no BIOS F_32a dated 01/15/2021.
Latest batch of BIOS's I received on 01/15/2021 (X570 and B550 BIOS date 01/14/2021)....(X470 and B450 BIOS date 01/15/2021).
All other F32a and F12a BIOS's is dated 01/14/2021 .
If you download first F32a, must be also from 01/13/2021 which I must delete and after rename to F_32a.
@stasio:
I downloaded all three F32a BIOS versions here. The only difference is the BIOS date. Only the second version with the date January 14th, 2021 has the ID for AGESA 1.1.0.0 in the BIOS. All others have no other ID.
This one you are right.
BIOS with ID is now F32a (Agesa 1.1.0.0) dated 01/14/2021 (my second post).
BIOS without ID (no info in CPU-Z or AIDA64) is "first" F32a and last F_32a (same BIOS) dated 01/13/2021.
I renamed every BIOS dated 01/13/2021 to F_32a or F_12a.
There is no BIOS F_32a dated 01/15/2021.
Latest batch of BIOS's I received on 01/15/2021 (X570 and B550 BIOS date 01/14/2021)....(X470 and B450 BIOS date 01/15/2021).
All other F32a and F12a BIOS's is dated 01/14/2021 .
If you download first F32a, must be also from 01/13/2021 which I must delete and after rename to F_32a.
This one you are right.
BIOS with ID is now F32a (Agesa 1.1.0.0) dated 01/14/2021 (my second post).
BIOS without ID (no info in CPU-Z or AIDA64) is "first" F32a and last F_32a (same BIOS) dated 01/13/2021.
Hi, can you send me the B550i pro AX latest bios? Thanks
Warning
Some of beta BIOSes are still undergoing compatibility testing. GIGABYTE is sharing these BIOSes for testing purposes only and are not meant for general release. If you are not familiar with beta BIOS testing, then please only flash the recommended release BIOSes that are posted on the GIGABYTE website, as only release
Comment