I recently bought a Foxconn motherboard with the SiS chipset, I have 1gb DDR 400 ram installed.
But the CL level is 3.0 on these rams of chips but the bios detects them at 2.5, It will allow me to overclock but I am not sure what settings I should use for timing.
I am also having an issue with the mainboard wanting to heat up, but not the CPU.
CPU around 33c idle, 51c at 100%. but the system board from what the bios says goes anywhere around 45c-62c.
I'm not sure if its correct or not.
Any ideas?
But the CL level is 3.0 on these rams of chips but the bios detects them at 2.5, It will allow me to overclock but I am not sure what settings I should use for timing.
I am also having an issue with the mainboard wanting to heat up, but not the CPU.
CPU around 33c idle, 51c at 100%. but the system board from what the bios says goes anywhere around 45c-62c.
I'm not sure if its correct or not.
Any ideas?
Comment