New thread, incase folks don't want to recheck that other one since it's a different problem...
Basically, I just tried to boost my bus speed from 166 to 200, as another thread this is a good try with barton cores. But...
I'm not overclocked because my machine won't go past the post screen. It actually stops and says "your computer is running in safe mode. You need to go into the Bios and set the clock speed properly per your CPU that we recognized". it will even show it's running at 1250MHz (1.25GHz) in a safe mode.
The MB is seeing that my bus speed is not set correct per the CPU I have installed, and it's basically telling me to F off.
Not sure of any settings per that MB or Bios that I need to check or uncheck to allow a different bus speed setting?
Basically, I just tried to boost my bus speed from 166 to 200, as another thread this is a good try with barton cores. But...
I'm not overclocked because my machine won't go past the post screen. It actually stops and says "your computer is running in safe mode. You need to go into the Bios and set the clock speed properly per your CPU that we recognized". it will even show it's running at 1250MHz (1.25GHz) in a safe mode.
The MB is seeing that my bus speed is not set correct per the CPU I have installed, and it's basically telling me to F off.
Not sure of any settings per that MB or Bios that I need to check or uncheck to allow a different bus speed setting?
Comment