If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
you could make one yourself with your current case, and nice loose hinge...just cut a hole in the tol of your case,and use the hinge to reattach that piece to your case, on the under side of the top....add a handle, or what not and you have the same....do you already have a top mount exhaust?
Heck, I don't even have a case. :) I am looking to get an older AOpen tank for the much-needed home PC upgrade, then chop it up with a Ahanix Blu I front panel and then get as much airflow going through it. I've lost 2 Western Digital hard drives in 2 months for some reason, but I suspect it was heat related. So this time I want monitoring.
I'm used to plain and simple towers, but I think this time I would prefer something a little cooler and feel like building it but trying for a clean OEM look just in case I decide to flog it. The blowhole surround of the X-Wing is very tidy, but I suspect it can be made from some resin, glassfibre. aluminium and the spare latch from the wife's prized Bribantia trash can ( :D ).
But the best method is to perhaps find a pre-made item just like this.
Comment