since i'm not getting any answer from the support (not even 1 email received :( ), is there anybody knowing how to fix a SSD disk when it was flashed from 1571 to 1916 firmware, wich locked the drive?
Announcement
Collapse
No announcement yet.
How to fix a 64GB pro IV SSD when flashed from firmware 1571 to 1916?
Collapse
X
-
Re: How to fix a 64GB pro IV SSD when flashed from firmware 1571 to 1916?
i just got an answer from Runcore support:
Dear customer
We do apologize for the inconvenience.
For some SSDs, it needs to be update to 1819 before to 1916.
Please read the instruction attached carefully, and run the 1819 firmware updating process again.
Also, before connect the drive via USB connector, u might need tweezers to connect those two "J1" holes in order to set the drive back to factory mode.
Regards,
Runcore support
with the good firmware :)
but now... should i connect the J1 jumper when the disk is connected through USB or not?
-
Re: How to fix a 64GB pro IV SSD when flashed from firmware 1571 to 1916?
Originally posted by lehua768We do apologize for the inconvenience.For some SSDs, it needs to be update to 1819 before to 1916.
Please read the instruction attached carefully, and run the 1819 firmware updating process again.
Also, before connect the drive via USB connector, u might need tweezers to connect those two "J1" holes in order to set the drive back to factory mode.since i'm not getting any answer from the support (not even 1 email received :( ), is there anybody knowing how to fix a SSD disk when it was flashed from 1571 to 1916 firmware, wich locked the drive?
Would it be comfortable if you send some screenshots of your SSD and the adaptor to [email protected]? We may then be able to locate the relevant reinitializing file for you.
Thank you
Comment
Comment