I recently built a new system with an i7-6700k, a Gigabyte GA-Z170x Gaming G1 motherboard, and a 32GB Ripjaws V kit (F4-3200C16Q-32GVK).
For the life of me I cannot get the RAM to run at anything other than the stock 2133mhz speeds. The BIOS has many more options than I am familiar with but I have tried the following:
Selected XMP profile = no boot
Selected XMP profile and adjusted system agent voltage = no boot
Selected XMP profile and adjusted system agent voltage and VCCIO voltage = no boot
Manually set memory multiplier to 3200mhz and adjusted above voltages = no boot
Manually set memory multiplier at various settings below 3200mhz and adjusted above voltages = no boot
As I'm learning more about the various options and their impacts on system stability I have learned that the recommendations I had about setting system agent and VCCIO to 1.25v may have been a bit much and may have contributed to the issue. I plan on going back and trying lower voltages. Stock voltage does not work though.
The above has been tried with the CPU at stock speeds and overclocked with no difference (so far).
Does anyone have any solid tips I can try to get this running at rated speeds (or at least close)? Any good "baby steps" recommendations I should follow?
Thanks for any help!
EDIT: I have also tried manually setting RAM voltage to 1.35v, I forgot to mention that earlier.
For the life of me I cannot get the RAM to run at anything other than the stock 2133mhz speeds. The BIOS has many more options than I am familiar with but I have tried the following:
Selected XMP profile = no boot
Selected XMP profile and adjusted system agent voltage = no boot
Selected XMP profile and adjusted system agent voltage and VCCIO voltage = no boot
Manually set memory multiplier to 3200mhz and adjusted above voltages = no boot
Manually set memory multiplier at various settings below 3200mhz and adjusted above voltages = no boot
As I'm learning more about the various options and their impacts on system stability I have learned that the recommendations I had about setting system agent and VCCIO to 1.25v may have been a bit much and may have contributed to the issue. I plan on going back and trying lower voltages. Stock voltage does not work though.
The above has been tried with the CPU at stock speeds and overclocked with no difference (so far).
Does anyone have any solid tips I can try to get this running at rated speeds (or at least close)? Any good "baby steps" recommendations I should follow?
Thanks for any help!
EDIT: I have also tried manually setting RAM voltage to 1.35v, I forgot to mention that earlier.
Comment