Motherboard GA-P67A-UD4-B3 front USB port connector.

[Midnight001]

Hi, i have front a USB port connector that i haven't figured out where to put them in. It looks like this (like the one in the middle).

I'm not sure if i need some kind of adapter. Here's a picture of the board i have for reference.

http://www.cfd.co.jp/gigabyte/motherboard/ga-p67a-ud4-b3/dl_p67a-ud4-b3.jpg

[Acebmxer]

Re: Motherboard GA-P67A-UD4-B3 front USB port connector.






See page 28 in your manual

[Lsdmeasap]

Re: Motherboard GA-P67A-UD4-B3 front USB port connector.

Stack the two on the right shown in the image, the connect to any front panel USB 2.0 header making sure you haev them stacked correctly so the wires match up with the below diagram

It's just a split header is all, same as using a 10 pin one. One on top, one on bottom, with the Red or Vcc wire for each being on the outside-right, ground inside left (on the no pin side)



9. No Pin
10. NC = no connected/no cable (Or you can connect an additional ground there if you like, from either header or both spliced together, but it's not required)

[Midnight001]

Re: Motherboard GA-P67A-UD4-B3 front USB port connector.

Thanks guys, i didn't realize VCC meant power & when i first installed the board i looked at the diagram wrong on page 28. I thought i needed a special connector or replace the front USB ports for that.

They work great now, thanks again!