If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
System Memory Multiplier ..............: Cannot change this
Memory Frequency (Mhz) ..............: 800
DRAM Timing Selectable ................: [Manual]
Standard Timing Control
CAS Latency Time........................ 6
tRCD ......................................... 6
tRP'........................................... 6
tRAS.......................................... 18
Set all Suggested below to highest Values first. Then later you can lower, one at a time, testing as you go
I haven't changed the Standard Timing Control i.e. CAS Latency Time, tRCD, tRP' & tRAS. Should I lower those as well ? If so, How much ?
Oh and show I keep lowering the Advanced Timing Control settings gradually to the lowest figures quoted by you ?
Last edited by makaveli-313; 06-23-2010, 08:28 AM.
I lowered it to the lowest listed settings in the post by Lsdmeasap but I think it resulted in the same memscores as my default one so I reverted them to the first settings I did and received these scores. I think I'll stick with them unless someone else has any ideas to improve it :)
Comment