Tweet
Hey guys I posted this on XS forums for the 4.5 LinX stable thread. I dropped vcore down to 1.3875 in bios and testing might need to go a notch up. Any way here is first results.
Just bought a 920 as my 930 would not go past 4.2. I had it boot to 4.5 but forget about getting it stable. I couldn't get it to run 4.2 with HT that took to much voltage for my liking. Now I just installed this cpu yesterday and this thing just blew me away.. Here is my first stab at 4.5 with this chip. The voltage is high for HT off as I was trying with HT on and turned it off to see if I was at least close to being stable. Dont Add this to the list yet I think I can lower the volts a bit with 4c/4t and then make a pass with 4c/8t and then push higher. 1.4375 was set in bios.
Batch #3927A440
Edit - Just remembered has to be 20 pass stable which im sure this is will be.
Just bought a 920 as my 930 would not go past 4.2. I had it boot to 4.5 but forget about getting it stable. I couldn't get it to run 4.2 with HT that took to much voltage for my liking. Now I just installed this cpu yesterday and this thing just blew me away.. Here is my first stab at 4.5 with this chip. The voltage is high for HT off as I was trying with HT on and turned it off to see if I was at least close to being stable. Dont Add this to the list yet I think I can lower the volts a bit with 4c/4t and then make a pass with 4c/8t and then push higher. 1.4375 was set in bios.
Batch #3927A440
Edit - Just remembered has to be 20 pass stable which im sure this is will be.
Comment