I have got 2x 2GB Corsair memory modules with my Gigabyte P55-USL3, Intel i5 CPU and using Windows 7 64Bit.
The RAM is installed in slots 1 and 3 (white) as indicated by the manual. However, when I boot up the system Windows registers as "4.00GB (2.00 GB usable)"
In the BIOS, the memory is shown as only having 2GB. However, if in the BIOS I go to the MIT MB Intelligent Tweaker and examine the status, it reports both modules but that only module 3 is enabled. It shows that there is memory installed in both slots 1 and 3 but only slot 3 is enabled. How do I enable slot 1?
The RAM is installed in slots 1 and 3 (white) as indicated by the manual. However, when I boot up the system Windows registers as "4.00GB (2.00 GB usable)"
In the BIOS, the memory is shown as only having 2GB. However, if in the BIOS I go to the MIT MB Intelligent Tweaker and examine the status, it reports both modules but that only module 3 is enabled. It shows that there is memory installed in both slots 1 and 3 but only slot 3 is enabled. How do I enable slot 1?
Comment