Hi all, I was told this was a good place to ask about this. I've just upgraded my system, new mobo and case, so I took everything and swapped it out of my old system, got everything installed and now I can't seem to get windows to run or even install sometimes (tried both Vista and 7 64-bit home premium about a dozen times each). Best case scenario so far is I get Vista installled and then it freezes or crashes while I try and install my wifi drivers.
I disabled C1E and EIST. Only one stick of memory is currently in the system, at 2.1 V. Everything else is 'stock' in the bios. I've tried setting the memory to 800, no good, tried changing the MCH voltage up and down, no good.
Any help would be greatly appreciated. I'm a photography student and I have a TB or data on two externals right now waiting to be put back into the system... getting a little nervous.
Gigabyte GA-EP45-UD3P
Wolfdale E8400 @ 3.00 Ghz
PNY GTX 275 video card
8 GB OCZ Platinum Rev.2 DDR2 8500
OCZ Agility 60 GB SSD
Kingston 60 GB SSD
Corsair TX 750 psu
ATCS 840 coolermaster case
LG CD/DVD Burner
D-Link Xtreme-N DWA-552 wifi
I disabled C1E and EIST. Only one stick of memory is currently in the system, at 2.1 V. Everything else is 'stock' in the bios. I've tried setting the memory to 800, no good, tried changing the MCH voltage up and down, no good.
Any help would be greatly appreciated. I'm a photography student and I have a TB or data on two externals right now waiting to be put back into the system... getting a little nervous.
Gigabyte GA-EP45-UD3P
Wolfdale E8400 @ 3.00 Ghz
PNY GTX 275 video card
8 GB OCZ Platinum Rev.2 DDR2 8500
OCZ Agility 60 GB SSD
Kingston 60 GB SSD
Corsair TX 750 psu
ATCS 840 coolermaster case
LG CD/DVD Burner
D-Link Xtreme-N DWA-552 wifi
Comment