Hello all. I just built a brand new pc. 4670 non-k, z87x-ud4h (F7) BIOS and 16 gb (4gb X 4) of Ripjaws X F3-14900CL9. I cannot get the thing stable when using XMP profile 1.
I had to bring the dram voltage up to 1.5 manually in uefi and still have not had success. It's sporadic, all dimms have been thoroughly tested for over 12 hours each using two PC's both at 1600mhz and 1866mhz. The modules check out fine. I can run any combination of them them without issue in an 8gb (4gb x 2) total config using either channel A or B. It's when I put all four dimms in the motherboard that these random stop errors and BSODs pop up.
Could this be an under-volt issue? Any options with Gigabyte boards as far as power adjustments go to help with this? Any help would be extremely helpful.
Regards...
I had to bring the dram voltage up to 1.5 manually in uefi and still have not had success. It's sporadic, all dimms have been thoroughly tested for over 12 hours each using two PC's both at 1600mhz and 1866mhz. The modules check out fine. I can run any combination of them them without issue in an 8gb (4gb x 2) total config using either channel A or B. It's when I put all four dimms in the motherboard that these random stop errors and BSODs pop up.
Could this be an under-volt issue? Any options with Gigabyte boards as far as power adjustments go to help with this? Any help would be extremely helpful.
Regards...
Comment