If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I went ahead and ordered a new BIOS chip, it did nothing to change anything
Do you have IPMI? It turns out mine do not register the +12V. I replaced the PSU and the problem is still there. Bill asked me to RMA the board back if nothing helped after PSU switch. Well, it is now with ASRock and it will take 5-7 days for them to have it fixed.
I have the same problem. It happened about the same time as yours. I exchange memory modules just to make sure it is not the memory, hooked the board directly to a monitor, and did a CMOS reset with plug off, battery off, and >30 secs press on the power button. The result is the same.
I suspect corrupt BIOS EEPROM. I already sent an email to Bill about this. Let's see how this goes...
Yet another one whose C2750D4I has stopped POSTing, I've added specs to my profile, which had been working for a good 9 months until one day where it just stopped POSTing.
When starting the computer, IPMI show no change in the video output.
The fans start at a high RPM, but shortly after reduces speed to 400-500 RPM.
I've tried using the RAM from my main computer; a pair of Kingston 16GB non-ECC (9905403-559.A00LF), and a Silverstone SX500-LG PSU, but neither made any difference.
I've also tried disconnecting all components but the motherboard itself, still no change.
I've also tried clearing CMOS, also no change here.
Any suggestions are welcome
Last edited by dotted; 07-06-2016, 03:01 PM.
Reason: Formatting
Leave a comment: