I just got my system all put together. But, the board won't post. It keeps coming up as boot code: A2. Which in the manual suggests a problem with a SATA device. I have 2 Corsair Force 3 SSDs. I had intended on running RAID with them. Anyway, on first boot A2 came up. So I powered down and unhooked both of the SSDs, reset CMOS, and hooked up one of the SSDs and rebooted. Same thing A2. Then I unhooked that one and hooked up the other one. Same thing again, A2. The drives are new, I haven't used them previously. So I plan to hook them up on my other rig and see if it will recognize them.
Regardless, can anyone on here suggest a possible solution? This is my first attempt to use an SSD, so I really don't know anything about them. I don't have any other hard drives connected, I do have a Blu Ray drive connected.
My system specs. Keep in mind I haven't even booted yet, so nothing is configured.
ASrock z97 OC Formula
Intel I7 4790k
G Skill 8x2 GB DDR3 2666 MHz
SLI Asus GTX Titans
Cooler Master 1250 watt PSU
Pioneer BD-R
Corsair Force 3 SSD 240 GB x 2
Regardless, can anyone on here suggest a possible solution? This is my first attempt to use an SSD, so I really don't know anything about them. I don't have any other hard drives connected, I do have a Blu Ray drive connected.
My system specs. Keep in mind I haven't even booted yet, so nothing is configured.
ASrock z97 OC Formula
Intel I7 4790k
G Skill 8x2 GB DDR3 2666 MHz
SLI Asus GTX Titans
Cooler Master 1250 watt PSU
Pioneer BD-R
Corsair Force 3 SSD 240 GB x 2
Comment