Anyone also using 1.35V Memory on this board?
When I go into IPMI it is constantly triggering "Lower Non-Critical (LNC)" status errors for the VCCM sensor because the threshold is 1.35V. Does anyone know how to change the thresholds for these events? I know they are innocuous, but it is annoying to see them constantly.
One thought I had was to go into the BIOS and change the memory voltage to 1.36V or whatever the next higher option is above 1.35 to at least make the events go away. Any thoughts on this?
In case it matters, I am using Kingston KVR16LE11L/8 sticks. They are DDR3 1600 CL11 ECC UDIMMs. Currently in the middle of a memtest86 that is going well so far -- 43% 1st pass.
Thanks.
When I go into IPMI it is constantly triggering "Lower Non-Critical (LNC)" status errors for the VCCM sensor because the threshold is 1.35V. Does anyone know how to change the thresholds for these events? I know they are innocuous, but it is annoying to see them constantly.
One thought I had was to go into the BIOS and change the memory voltage to 1.36V or whatever the next higher option is above 1.35 to at least make the events go away. Any thoughts on this?
In case it matters, I am using Kingston KVR16LE11L/8 sticks. They are DDR3 1600 CL11 ECC UDIMMs. Currently in the middle of a memtest86 that is going well so far -- 43% 1st pass.
Thanks.
Comment