Hello all, my first post on the forum.
Im having an issue with my memory on my ASrock Extreme4 gen 3 mobo. In DIMM slots B1+B2 i have installed 4gb (2x2gb) of corsair vengeance at 1600mhz. That runs fine and well by itself and posts perfectly. The other day i purchased another set of the EXACT same memory, Vengeance 2x2gb 1600mhz. When i install it into the sets a1+a2 so every DIMM slot is full.. i get the error message 30 on DR.Debug, Ive made sure the DIMMS are in fine and ive swapped the 2 new DIMMS into the other 2 slots alone and they run fine, so its not the DIMMS themselves..
Could anyone advise me on what i could undergo to perhaps get past error 30?
PS. Error 30 = 'Reserved for ASL (See ASL status codes bellow)' There are no ASL status codes bellow...
Thank you for your time reading this and hope you can help me
~Lukeyallop
Im having an issue with my memory on my ASrock Extreme4 gen 3 mobo. In DIMM slots B1+B2 i have installed 4gb (2x2gb) of corsair vengeance at 1600mhz. That runs fine and well by itself and posts perfectly. The other day i purchased another set of the EXACT same memory, Vengeance 2x2gb 1600mhz. When i install it into the sets a1+a2 so every DIMM slot is full.. i get the error message 30 on DR.Debug, Ive made sure the DIMMS are in fine and ive swapped the 2 new DIMMS into the other 2 slots alone and they run fine, so its not the DIMMS themselves..
Could anyone advise me on what i could undergo to perhaps get past error 30?
PS. Error 30 = 'Reserved for ASL (See ASL status codes bellow)' There are no ASL status codes bellow...
Thank you for your time reading this and hope you can help me
~Lukeyallop
Comment