Hi All,
I just built a new system yesterday with the following specifications
ASRock Fata1ity Z68 Professional Gen3
Intel iCore 7 2600k
Corsair Vengeance 4GBx4
Kingston SSDNow KC100 120GB
XFX Radeon HD 6950 2GB
LG Bluray Burner
Corsair D600 Case
Corsair HX850 Power Supply
The system powered up no problems once I set everything up I installed the OS and all of the drivers. I then played some games for about an hour and shutdown my system. When I went to power it back on the system went into UEFI setup automatically I went ahead and selected exit and discard the settings. The the system reboots back into UEFI Setup once again so this time I select save settings and exit after I did that the system rebooted but this time just froze on boot up screen I looked at the board and saw error code 0d. I then follow the procedures to clear the CMOS to factory default powered the system back on the system worked. I then restarted the system and went and set my hard drive settings back to AHCI from IDE and saved and exited the UEFI setup only to come back to the same issue with the system freezing on the boot screen. I have reseated the memory, hard drive, bluray player, video card. Even after all of this it will start up once fine but freeze on again after one reboot and goes back to error code 0d I have also removed the video card and used the onboard video card to come to the same issue. Also in order to get it to boot up I have to clear the CMOS every time it freezes. I am out of ideas I am just about to go to the store and have the board replaced. Any assistance will be greatly appreciated.
Thanks and Regards,
Cris
I just built a new system yesterday with the following specifications
ASRock Fata1ity Z68 Professional Gen3
Intel iCore 7 2600k
Corsair Vengeance 4GBx4
Kingston SSDNow KC100 120GB
XFX Radeon HD 6950 2GB
LG Bluray Burner
Corsair D600 Case
Corsair HX850 Power Supply
The system powered up no problems once I set everything up I installed the OS and all of the drivers. I then played some games for about an hour and shutdown my system. When I went to power it back on the system went into UEFI setup automatically I went ahead and selected exit and discard the settings. The the system reboots back into UEFI Setup once again so this time I select save settings and exit after I did that the system rebooted but this time just froze on boot up screen I looked at the board and saw error code 0d. I then follow the procedures to clear the CMOS to factory default powered the system back on the system worked. I then restarted the system and went and set my hard drive settings back to AHCI from IDE and saved and exited the UEFI setup only to come back to the same issue with the system freezing on the boot screen. I have reseated the memory, hard drive, bluray player, video card. Even after all of this it will start up once fine but freeze on again after one reboot and goes back to error code 0d I have also removed the video card and used the onboard video card to come to the same issue. Also in order to get it to boot up I have to clear the CMOS every time it freezes. I am out of ideas I am just about to go to the store and have the board replaced. Any assistance will be greatly appreciated.
Thanks and Regards,
Cris
Comment