That's really tidy, BUhockey, did you make any of those rounded cables? (Bit difficult to tell from pic.)
I'm just rebuilding my setup and am all tangled up in wires - I've put a CDRom drive in the top bay, left an empty bay underneath it, then CD-RW under that - thinking about heat. But these P4-ready cases have more PSU wires than ATX-only, so I may have to move the top drive down. Or can I tuck the spare PSU stuff in between the 2 drives?
As you can guess, I'm not exactly the most experienced builder, and I'm a bit worried about bundling up cables in case they overheat??????
I've got 80mm Evercools front and back, and a slot fan beside the AGP video card; now i've put a 2-fan Akasa cooler on my new 120GXP. Power is Antec 340W. CPU is non-overclocked 1gb Athlon 200fsb with non-screaming fan on heatsink.
Please tell me if I'm in danger of overloading.
I'm just rebuilding my setup and am all tangled up in wires - I've put a CDRom drive in the top bay, left an empty bay underneath it, then CD-RW under that - thinking about heat. But these P4-ready cases have more PSU wires than ATX-only, so I may have to move the top drive down. Or can I tuck the spare PSU stuff in between the 2 drives?
As you can guess, I'm not exactly the most experienced builder, and I'm a bit worried about bundling up cables in case they overheat??????
I've got 80mm Evercools front and back, and a slot fan beside the AGP video card; now i've put a 2-fan Akasa cooler on my new 120GXP. Power is Antec 340W. CPU is non-overclocked 1gb Athlon 200fsb with non-screaming fan on heatsink.
Please tell me if I'm in danger of overloading.
Comment