If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Good to see ya back MySTiCuSS.
150 should give you better performance if ya can keep it stable but really both are out of spec for ya hardware but I can't see that there would be much between either. :smokin:
<center>:cheers:</center>
Never much bothered checkin' if those BIOS' had an extra divider but those boards are very finicky so I leave the one here stock. :smokin:
<center>:cheers:</center>
Ok then he may get better performance from the 147MHz as the AGP and PCI buses are workin' that bit harder than runnin' below spec. :smokin: MySTiCuSS what are your results between the two settings with Sandra and 3DMark 2001SE? :?:
<center>:cheers:</center>
Next time ya unlock one make sure that all those fine wires are pushed back down after cleanin' the pits out (magnifyin' glass is helpful). :smokin:
<center>:cheers:</center>
lol to this do it;s still a puzzle how the poor thing died...i'm pretti sure the unlocking job i did was ok....but there's no physical damage anywhere on the cpu....maybe one of these days i'll give it another go...i have a felling about it this time:D
lol to this do it;s still a puzzle how the poor thing died...i'm pretti sure the unlocking job i did was ok....but there's no physical damage anywhere on the cpu....maybe one of these days i'll give it another go...i have a felling about it this time:D
What is your Temp. after overclock to 1.7ghz... As i also overclock to 148*11.50 but temp at 55c to 57c..
What sort of HSF are ya usin' as I can keep mine below 50c @ 1730MHz with the Volcano 7+ on medium fan speed? :?:
<center>:cheers:</center>
Comment