Good morning guys, I am a first time poster and a bit of a noob.
I have the following setup
Gigabyte X58A-UD3R Rev.1 - BIOS:FE
Core I7 930
ATI 5870
1TB WD black SATA3 (2)
8 Gigs DDR3 Ram
I just purchased a Vertex 3 120Gig SSD.
Now from what I am reading, the Marvell 9128 Controller is a bloody waste of time and does not work correctly.
My question is as follows.
I see there is a new driver:
1) Do I use them? Or do I continue using the Intel port?
2) If using the Intel port do I need to install: Intel Matrix storage manager?
I do not now want to upgrade the board and processor :(
I also do not know what to enable in my BIOS - as I said I am a noob when it comes to this stuff.
Any help would be greatly appreciated.
I have the following setup
Gigabyte X58A-UD3R Rev.1 - BIOS:FE
Core I7 930
ATI 5870
1TB WD black SATA3 (2)
8 Gigs DDR3 Ram
I just purchased a Vertex 3 120Gig SSD.
Now from what I am reading, the Marvell 9128 Controller is a bloody waste of time and does not work correctly.
My question is as follows.
I see there is a new driver:
1) Do I use them? Or do I continue using the Intel port?
2) If using the Intel port do I need to install: Intel Matrix storage manager?
I do not now want to upgrade the board and processor :(
I also do not know what to enable in my BIOS - as I said I am a noob when it comes to this stuff.
Any help would be greatly appreciated.
Comment