Hi this is my current issue as I've posted elsewhere:
I've RMA'd the board and the issue persists. It seems as though other people also have this problem: Gigabyte GA-P67A-UD3 - Windows 7 64 bit freezing/Locking UP though different boards.
I've talked to a GB tech support and this is what he said:
Right now, I'm testing that. Does anyone have any insights?
P.S. My ram is this module: G.SKILL Sniper 8GB (2 x 4GB) 240-Pin DDR3 SDRAM DDR3 1600 (PC3 12800) Desktop Memory Model F3-12800CL9D-8GBSR. It's not on UD7's list of supported memory, as listed on the product website. Could this be the cause?
Hello, I've got my i7-2600k, UD7, 8gb 1600mhz (2x4gb sticks), 2x6950 crossfire 4-5 days ago. From my old build, I've savaged an AX850, c300 128gb, 1x1tb wd green, 1x640gb wd black.
So I put together my new build and installed W7 Enterprise x64, but soon I started noticing problems. My computer was freezing whenever I idled. It also did as I was installing programs, but now, mostly whenever I idled. So, I decided to do some diagnostics:
I booted into safe mode, the problem was gone (no freeze for 5-6 hours?).
I ran memtest, ram was fine.
I did a clean boot (disabled all non microsoft services and all programs), the problem persisted, so it must be the drivers.
I reinstalled W7 Enterprise x64, left it idle with a clean install. It didn't freeze.
Then, I followed up by installing the following drivers through the download page on GB:
Intel INF installation: 9.2.0.1016
Intel Management Engine Interface: 7.0.0.1118
Realtek LAN Driver: 7.032
Marvell Console Driver (SATA3): 1.0.0.1014
NEC USB 3.0 Driver: 2.0.30.0
I left it idle for 30 mins, it froze.
Finally, I decided to switch to install W7 Ultimate x64, and installed only the following drivers:
Realtek LAN Driver & Intel INF installation.
I left it on overnight, and it froze again.
Now, I installed a fresh copy of W7 ultimate x64 and am letting it idle to for a good 6-7 hours to see if it crashes.
The following things I've done to my installations:
Set power profile to high performance, disabled automatic screen turn-off, disabled hdd sleep after x mins, disabled allowing the LAN to wake computer.
Then if it doesn't freeze, I'm going to just try installing the LAN driver and pray to god that it doesn't freeze.
Does anyone have any other ideas? Could it be a bad motherboard? Perhaps, a bad graphics card? (I doubt it, since I've installed 11.11a and gamed for a few hours on it and nothing happened... but who knows) Or, is there anything else I'm missing?
Thank you!
So I put together my new build and installed W7 Enterprise x64, but soon I started noticing problems. My computer was freezing whenever I idled. It also did as I was installing programs, but now, mostly whenever I idled. So, I decided to do some diagnostics:
I booted into safe mode, the problem was gone (no freeze for 5-6 hours?).
I ran memtest, ram was fine.
I did a clean boot (disabled all non microsoft services and all programs), the problem persisted, so it must be the drivers.
I reinstalled W7 Enterprise x64, left it idle with a clean install. It didn't freeze.
Then, I followed up by installing the following drivers through the download page on GB:
Intel INF installation: 9.2.0.1016
Intel Management Engine Interface: 7.0.0.1118
Realtek LAN Driver: 7.032
Marvell Console Driver (SATA3): 1.0.0.1014
NEC USB 3.0 Driver: 2.0.30.0
I left it idle for 30 mins, it froze.
Finally, I decided to switch to install W7 Ultimate x64, and installed only the following drivers:
Realtek LAN Driver & Intel INF installation.
I left it on overnight, and it froze again.
Now, I installed a fresh copy of W7 ultimate x64 and am letting it idle to for a good 6-7 hours to see if it crashes.
The following things I've done to my installations:
Set power profile to high performance, disabled automatic screen turn-off, disabled hdd sleep after x mins, disabled allowing the LAN to wake computer.
Then if it doesn't freeze, I'm going to just try installing the LAN driver and pray to god that it doesn't freeze.
Does anyone have any other ideas? Could it be a bad motherboard? Perhaps, a bad graphics card? (I doubt it, since I've installed 11.11a and gamed for a few hours on it and nothing happened... but who knows) Or, is there anything else I'm missing?
Thank you!
I've talked to a GB tech support and this is what he said:
I have attached you the F7f bios to test with, please use the @bios to update and load the defaults upon completing. Do attempt to only test with one memory module installed and test the memory configure to 1066mhz.
P.S. My ram is this module: G.SKILL Sniper 8GB (2 x 4GB) 240-Pin DDR3 SDRAM DDR3 1600 (PC3 12800) Desktop Memory Model F3-12800CL9D-8GBSR. It's not on UD7's list of supported memory, as listed on the product website. Could this be the cause?
Comment