I updated to bios FF2 fine, then I installed EasyTune 6 B10 (first install), checked vcore reading the the app and it was my normal vcore 0.944v idle/1.200v load used without the extra DVID.
For Vcore I use Normal + [DVID +0.6250v] / idle 1.008v , load 1.248v, after I opened ET6 for the first time on a fresh windows 7 x64, vcore was idle 0.944v and load 1.200v, those are the same volt I should get on stock but I was already @ 4GHz, I think ET6 read something wrong or it had set something automatically, I also checked with CPU-Z and it was 0.944v idle/1.200v load too. I restarted PC and vcore is back to 1.008v idle without changing anything. Also now when I open ET6 it reports fine 1.008v. It was only the first run of ET6 which read 0.944v idle, I can't reproduce the bug again. Only happened 1 time after I installed ET6 and opening it for first time.
For Vcore I use Normal + [DVID +0.6250v] / idle 1.008v , load 1.248v, after I opened ET6 for the first time on a fresh windows 7 x64, vcore was idle 0.944v and load 1.200v, those are the same volt I should get on stock but I was already @ 4GHz, I think ET6 read something wrong or it had set something automatically, I also checked with CPU-Z and it was 0.944v idle/1.200v load too. I restarted PC and vcore is back to 1.008v idle without changing anything. Also now when I open ET6 it reports fine 1.008v. It was only the first run of ET6 which read 0.944v idle, I can't reproduce the bug again. Only happened 1 time after I installed ET6 and opening it for first time.
Comment