CPU: QX9770
CPU Cooler: Zalman CNPS9900 LED
DDR2: PC2-8500 2GB Cruicial Ballistic
Board: GA-EP43-UD3L
Video: EVGA 8800 GTS 512MB
PSU: Thermaltake Toughpower 650W
Case: Antec P183 mid tower
Problem: After putting the board into case, connect case power, reset, wires, plugged in video card, Plug in power and turn on system. No video seen on monitor and system keeps rebooting. The reason I say it keeps rebooting is that, I can see CPU fan LED is on, LED on DDR comes on and there are 4 LEDs below CPU_fan connectors are all on. Then about 63 seconds, all LEDs & fans are off. Then LEDs & Fans come back on again in about 3 seconds. Video never comes on. Anyone knows what's going on? And suggestions? I already tried clearing the CMOS by touching the CLR_CMOS jumper with the screw driver for a few sec while computer is unplugged.
CPU Cooler: Zalman CNPS9900 LED
DDR2: PC2-8500 2GB Cruicial Ballistic
Board: GA-EP43-UD3L
Video: EVGA 8800 GTS 512MB
PSU: Thermaltake Toughpower 650W
Case: Antec P183 mid tower
Problem: After putting the board into case, connect case power, reset, wires, plugged in video card, Plug in power and turn on system. No video seen on monitor and system keeps rebooting. The reason I say it keeps rebooting is that, I can see CPU fan LED is on, LED on DDR comes on and there are 4 LEDs below CPU_fan connectors are all on. Then about 63 seconds, all LEDs & fans are off. Then LEDs & Fans come back on again in about 3 seconds. Video never comes on. Anyone knows what's going on? And suggestions? I already tried clearing the CMOS by touching the CLR_CMOS jumper with the screw driver for a few sec while computer is unplugged.
Comment