EX58 & Corsair Dominator XMP Setting

[kizzie]

Re: EX58 & Corsair Dominator XMP Setting

Yeah, I had a good feeling a lot of these numbers where to high but was unsure. And in my (stupidity) desperation I was trying anything to figure out some form of a solution. I'm very mixed up on what is to high or to low. What I think currently is nothing above +300mv or 1.5 QPI is a good idea (testing showed that was a bad idea). But like I said I am just trying find a solution with this RAM. I am very sure at this point though that these Dominators are possessed with an evil demon.

[wazza300]

Re: EX58 & Corsair Dominator XMP Setting

Yeah, I had a good feeling a lot of these numbers where to high but was unsure. And in my (stupidity) desperation I was trying anything to figure out some form of a solution. I'm very mixed up on what is to high or to low. What I think currently is nothing above +300mv or 1.5 QPI is a good idea (testing showed that was a bad idea). But like I said I am just trying find a solution with this RAM. I am very sure at this point though that these Dominators are possessed with an evil demon.

its much easier to loosen ram timings than risk overvolting ram,DONT go any higher than 1.66 for ram voltage and qpi 1.3000 should be more than enuff if i can run at 1800mhz with 1.2800 [email protected] then youll be able to run at 1600mhz youd be better off setting timings at 8-8-8-28 or 9-9-9-24 @1600mhz then test with thatkeep cpu voltage on normal i have with no problems at all