Tweet
Does the plate on bottom of board (for waterblock) stay on if just using fan? My fan bracket in on but not exactly flat?
-
-
Re: Ex58-ud4p
I am not aware that it is for a waterblock. I have water cooling and the bracket I use for the block is the same as I would use for a fan/heatsink. Your bracket should fit neatly over that plate.i7 920 DO @ 4410 210*21 Watercooled
Gigabyte GA-Ex58 ud4p
3X2gb Mushkin DDR3 1600
2x4870 1GB Ati Crossfire.
Intel X-25M SSD OS drive
G.Skill Titan 128gb SSD X2 RAID 0 Data
Corsair HX850 PSU
Windows 7 x64 7600 -
Re: Ex58-ud4p
I would clean all the thermal lubricant off of that cpu and waterblock with some 91% rubbing alcohol and run a piece of sandpaper over the flat side of the waterblock. Clean again with rubbing alcohol and add new thermal lubricant. Then check it for a flush seat again.Last edited by artdrivers; 08-09-2009, 09:26 AM.http://forums.tweaktown.com/gigabyte...ench-test.html
http://www.gigabyte-usa.com/FileList...ios_qflash.pdf
Phenom II 945 @ 3.2Ghz w/Thermaltake Big Typhoon Pro 14 CPU Cooler
Gigabyte GA-MA78GM-S2H rev.1.1 F11
Sapphire 3870HD / 100225L / 512MB / ddr4
4GB / Kingston / KHX8500D2K2/2GN / 5-5-5-18 / 1066Mhz
(2) WD Caviar / WD2500AAKS/ 250GB in SATA RAID-0
(1) WD Caviar / WD2500AAKS/ 250GB in SATA AHCI
(2) IDE's 1 8XdualDVDRW 1 52x32x52x CDRW
Antec /Neo HE550 / 550W
Mid size ATX case with show through panel
2) 80x80 front fans (1) 120x120 rear fan and small nb fan
Microsoft comfort curve USB keyboard 2000 ver.1.0
Logitech G500 USB mouse
Monitor: CMV937A
7.1+2 Channel High Definition ALC889A
Dual boot Windows 7 32bit home & Windows 7 64bit home
Comment
Comment