I just finished a new pc build, and I am having issues with my mobo (EP45-UD3R) /memory. Full Specs are in the sig...
On initial install (Bios F4), ram in dual channel config (1&3, 2&4) would not post, emitting short continuous beeps (power error). Removed one of the Dimms, everything posts and boots fine. Add the second Dimm in single channel config (1&2), everything posts and boots fine. Bios/mobo detected timing, but not proper voltage, manually adjusted voltage to 2.1v in bios...same no post/beeps.
Cleared Cmos, tried dual config, same results.
Updated Bios to F5, now Dual channel config does not post, no display, but only beeps once and spins all the fans. I have tried Dimms in 1&3 and 2&4, both with like results.
Any suggestions?
On initial install (Bios F4), ram in dual channel config (1&3, 2&4) would not post, emitting short continuous beeps (power error). Removed one of the Dimms, everything posts and boots fine. Add the second Dimm in single channel config (1&2), everything posts and boots fine. Bios/mobo detected timing, but not proper voltage, manually adjusted voltage to 2.1v in bios...same no post/beeps.
Cleared Cmos, tried dual config, same results.
Updated Bios to F5, now Dual channel config does not post, no display, but only beeps once and spins all the fans. I have tried Dimms in 1&3 and 2&4, both with like results.
Any suggestions?
Comment