1st post: Trying to set up new rig and am having the BSOD after setting up Raid & trying to boot up windows XP Pro. I have two WD Vraptor 300gb set up in 0raid connected to the purple Gigabyte sata plugs on the mob. The onboard-Sata/IDE device is enable. Also Sata Raid/AHCI mode enabled for AHCI (ICH9R) & Sata Port 0-3 native mode enabled (ICH9R also) for my G-sata & Rom drives are connected to the yelllow sata plugs. After booting up, the windows setup page starts, I press F6, after a short time I load the Gigabyte driver from the GB cd, then when windows setup starts, I get the BSOD saying a problem has been detected & windows has to shut down etc--. I get the stop 0x0000007B, 0x00000000 etc. It seems that the drivers were loading from the info scrolling at the bottom of the page. If I set my HDDs to the Ide mode, windows loads up without any problems. The tech support guy at Gigabyte was even scratching his head but I haven' contacted them again.
memory: Corsair Dominator 2x2gb ddr 1066 5,5,5,15, even though XP Pro
processor: Q9550-2.83 gb
HDD: (2) WD VelociRaptor 300gb
cooler: Zaleman 9500A
Roms-- (2) Samsung sata
Floppy
Memtest shows good & I don't want to OC right now, maybe later
MIT
Robust graphics booster--auto
Cpu clock rati--- [8x]
fine cpu clock ratio----- [+0.5]
cpu frequency -- 2.83 (333x8.50
cpu host clock control --Enabled
cpu host frequency---[333]
CIA2---- [disabled]
spd---------- auto
mem freq---- 1066
dram timing selectable-----manual 5,5,5,15
advanced timing control auto [default]
Everything else is default except for
system voltage control which is in auto.
Are these settings ok? I plan to occasionally run some games, general brousing and some video editing.
I have no idea what most of these settings are & don't know if I'm going in the right direction. I mainly want to find out if my Gig. sata controllers on the mob are/not working- maybe I need to return mob. As a last resort, I'll run in the IDE mode. I appologize for the long post! Thanks in advance
memory: Corsair Dominator 2x2gb ddr 1066 5,5,5,15, even though XP Pro
processor: Q9550-2.83 gb
HDD: (2) WD VelociRaptor 300gb
cooler: Zaleman 9500A
Roms-- (2) Samsung sata
Floppy
Memtest shows good & I don't want to OC right now, maybe later
MIT
Robust graphics booster--auto
Cpu clock rati--- [8x]
fine cpu clock ratio----- [+0.5]
cpu frequency -- 2.83 (333x8.50
cpu host clock control --Enabled
cpu host frequency---[333]
CIA2---- [disabled]
spd---------- auto
mem freq---- 1066
dram timing selectable-----manual 5,5,5,15
advanced timing control auto [default]
Everything else is default except for
system voltage control which is in auto.
Are these settings ok? I plan to occasionally run some games, general brousing and some video editing.
I have no idea what most of these settings are & don't know if I'm going in the right direction. I mainly want to find out if my Gig. sata controllers on the mob are/not working- maybe I need to return mob. As a last resort, I'll run in the IDE mode. I appologize for the long post! Thanks in advance
Comment