Antec 300 Power led front panel connection

[ralphf]

This is my first post. I have a GA-P35-DS3L MB installed in an Antec 300 case and have question about connecting the power led connector. The MB has a 3 pin Power LED connection (not shown in manual) and 2 pin Message/Power/Sleep LED connection. The Antec case came with only a 3 pin connector. Right now power light glows steady. When I exit in standby mode the light does not blink and I can't active the system with mouse or KB. Does anyone now if it's possible to convert 3 pin connector to 2 pin connector. I recently built a system with an Asus MB and had just the opposite problem. Why can't case manufacturers and MB manufacturers get it right? Thanks for any help.

[Lsdmeasap]

Re: Antec 300 Power led front panel connection

Mouse or keyboard must be set in the BIOS to wake your system, and may need to be PS/2

Where do you have it plugged in now? You can use the 3 pin header, you just have to be sure the wiring matches up

The Light will only blink for S1 sleep, not S3 as well.