LSD help me ^_^ i cant get my new rams stable on high bus frequency

[harry23lim]

i just bought a ram for my ep45 DS3R

team xtreem dark 1066 5-5-5-15 @ 2.2V

i need settings that will let me make this rams stable @ 1187mhz my memory latch is 200. 3.33c this is the only latch that let me boot up on high memory bus frequency

ACT to ACT Delay (tRRD)________ auto
Rank Write to READ Delay (tWTR)_______ auto
Write to Precharge Delay (tWR)________ auto
Refresh to ACT Delay (tRFC)___________ 42 (2X1Gb)
Read to Precharge Delay (tRTP)_________ auto
Static tRead Value (tRD)______________ 7 (1066Mhz)
Static tRead Phase Adjust________ auto

my voltage:

Cpu PLL___________1.5V
CPU termination_____1.3-1.4V( i tried both)
Cpu Reference______0.760 stock
Cpu V core_________1.43750(but due to v droop this is not accurate)
d ram voltage_______2.2V
d ram termination____auto
dram referance A____auto
D ram reference B___auto

MCH voltage_______1.3~ 1.4(tested both)
MCH/Dram reference auto
Mch reference_____ auto
ich/IO____________1.5V(stock)



another is 200 latch, 2.66c 946mhz and its stable on OCCT 2 hours

i cant let it boot on 400mhz latch. theres 1.13x there lower mhz than the 200 latch 3.33c but i cant get it to boot.

i tried 333 latch, only succesful on 2.40B 856mhz when i tried 3.33b 1187mhz i can't get it to boot.


heres my specs.

e4300@ 3.2GHZ 356x9 set 1.43750 on bios but on Cpu Z 1.392~1.3760 idle load 1.3760`1.34x this is because of the v droop of my board.
GA ep45 DS3R
team xtreem dark 1066


please help me make my rams stable :P
<!-- / message --><!-- edit note -->

[Lsdmeasap]

Re: LSD help me ^_^ i cant get my new rams stable on high bus frequency

Maybe more volts? I dont know much about a E4300

Try 655-18 for main timings
Refresh to ACT Delay (tRFC)___________ 50
Static tRead Value (tRD)______________ 8-10