I am almost hopelessly confused by the SATA on this board. I want the hard drives to operate in SATA 3Gb/s mode. Boot drive is connected to SATAII0 the others to SATAII1, 4 and 5. I am not setting up RAID. I installed Vista SP1 and then the drivers from the drivers disk.
Everything is working fine, but... the drives are being reported as IDE Master and Slave? Did I need to install the driver before installing Vista? It seemed like that was only needed for RAID?
I'd rather not have to reinstall Vista and programs, but I don't want bottlenecks either. Any advise?
Everything is working fine, but... the drives are being reported as IDE Master and Slave? Did I need to install the driver before installing Vista? It seemed like that was only needed for RAID?
I'd rather not have to reinstall Vista and programs, but I don't want bottlenecks either. Any advise?
Comment