I've got a P35-DS3R revision 2.0, F11 bios, Intel Q6600 and 2x OCZ DDR2 PC2-8500 Reaper HPC Edition. My problem is with the memory, it's supposed to be 1066Mhz but this motherboard refuses to run it at anything higher than 667Mhz. These are the settings for this memory for the board from OCZ's website:
I don't seem to be able to change it, its like it wont load my settings.. I will save the settings and exit. PC powers off for a couple of seconds, comes back on, if I check the bios - no change. I've tried just changing the voltage and the SPD and keeping everything else to auto, still no change!
Any advice will be really appreciated!
I don't seem to be able to change it, its like it wont load my settings.. I will save the settings and exit. PC powers off for a couple of seconds, comes back on, if I check the bios - no change. I've tried just changing the voltage and the SPD and keeping everything else to auto, still no change!
Any advice will be really appreciated!
Comment