I have been using the Q1900-ITX for a while with 4+4=8GB RAM and it has been working perfect. I need more RAM and the manual says 16GB max so I bought an 8GB module. I thought I better run MemTest86 before I continue using the system because the module I bought is used. MemTest86 (V6.0.0 Free) gives a lot of errors.
If I run MemTest86 with only one module (4GB or 8GB) or two 4GB modules it runs without problems. But if I have 4GB and 8GB modules installed it gives a lot of errors. Errors start in Test 1 [Address test, own address, 1 CPU] at 64%. For example:
Test: 1 Addr: 2400002D0 Expected: 00000002400002D0 Actual: FFFFFFFFFFFFFFFF
It does the same (even at the same 64% mark) if I swap the module locations.
4GB module: Hynix HMT351S6CFR8C
8GB module: Elpida EBJ81UG8BAS0-DJ-F
Can this be fixed in software (BIOS) or is it a hardware limitation?
If I run MemTest86 with only one module (4GB or 8GB) or two 4GB modules it runs without problems. But if I have 4GB and 8GB modules installed it gives a lot of errors. Errors start in Test 1 [Address test, own address, 1 CPU] at 64%. For example:
Test: 1 Addr: 2400002D0 Expected: 00000002400002D0 Actual: FFFFFFFFFFFFFFFF
It does the same (even at the same 64% mark) if I swap the module locations.
4GB module: Hynix HMT351S6CFR8C
8GB module: Elpida EBJ81UG8BAS0-DJ-F
Can this be fixed in software (BIOS) or is it a hardware limitation?
Comment