I have a new Fatal1ty Professional-M m-ATX board.
The CPU is a 2500k, and the memory is 4GB (2x 2GB OCZ DDR3 memory).
I turn on board and there is a load alarm, the Dr. Bios runs through numbers, and stops at A2 - IDE Detect. The alarm is going the whole time.
What does this mean?
What could this indicate.
Why does it get stuck on A2 - IDE detect, when the board has no IDE port?
How come the alarm is not mentioned in the manual?
The CPU is a 2500k, and the memory is 4GB (2x 2GB OCZ DDR3 memory).
I turn on board and there is a load alarm, the Dr. Bios runs through numbers, and stops at A2 - IDE Detect. The alarm is going the whole time.
What does this mean?
What could this indicate.
Why does it get stuck on A2 - IDE detect, when the board has no IDE port?
How come the alarm is not mentioned in the manual?