I am running a 2600K on my Z68 Extreme7 Gen3, Bios Ver. is 1.3, RAM is 4X4GB Corsair Vengeance DDR3 1600 C8 running at XMP mode [email protected], Graphic cards are HD6990+6970 CrossFire and one Force GT SSD+WD Black Cavier 1T
PSU is SilverStone 1200W
The problem is it's not able to overclock my CPU at all, once I modified any settings in BIOS, I will get the Debug code 71 or F1 or 2F and keep rebooting.
I was able to overclock the same CPU on my previous Asus P8Z68 Deluxe to [email protected] and it's very stabe.
Did I make any wrong settings on Extreme7?
My settings are as follows
CPU Ration Setting------------------47
Internal PLL Overvoltage------------Disabled
Intel SpeedStep Technology--------Enabled
Turbo Boost Power Limit------------Manual
Short Duration Power Limit----------300
Long Duration Power Limit-----------300
Long Duration Maintained------------1
Additional Turbo Voltage-------------Auto
Core Current Limit-------------------150
BCLK-------------------------------100
Spread Spectrum-------------------Disabled
Power Saving Mode-----------------Disabled
CPU Core Voltage-------------------Fixed Mode @ 1.390V
CPU Load-Line Calibration-----------Level 1
The rest settings remains auto by default.
PSU is SilverStone 1200W
The problem is it's not able to overclock my CPU at all, once I modified any settings in BIOS, I will get the Debug code 71 or F1 or 2F and keep rebooting.
I was able to overclock the same CPU on my previous Asus P8Z68 Deluxe to [email protected] and it's very stabe.
Did I make any wrong settings on Extreme7?
My settings are as follows
CPU Ration Setting------------------47
Internal PLL Overvoltage------------Disabled
Intel SpeedStep Technology--------Enabled
Turbo Boost Power Limit------------Manual
Short Duration Power Limit----------300
Long Duration Power Limit-----------300
Long Duration Maintained------------1
Additional Turbo Voltage-------------Auto
Core Current Limit-------------------150
BCLK-------------------------------100
Spread Spectrum-------------------Disabled
Power Saving Mode-----------------Disabled
CPU Core Voltage-------------------Fixed Mode @ 1.390V
CPU Load-Line Calibration-----------Level 1
The rest settings remains auto by default.
Comment