I have a MB model P67 Pro3

[nikkey2006]

I have a MB model P67 Pro3
The system is not coming.
When I start, I hear three long beeps and shows debug D6
What can be?

Thank you to anyone who can help

[ASRock TSD - Emily]

Re: I have a MB model P67 Pro3

Dear nikkey2006,

About the debug code shows "D6", it maybe caused by your VGA card.
System cannot recognize your VGA card, so the system cannot boot normally.

Please kindly refer to below suggestions for testing.
1. Reinstall your VGA card and check the power connector of the VGA card is connected correctly.
2. Use eraser to clean the golden finger of VGA card to try.
3. Please press "F9" to load BIOS default settings and adjust "Primary Graphics Adapter" to [PCI Express] to try.
4. If possible, please kindly change another VGA card to try.

Thanks!

Have a nice day
ASRock TSD Emliy

[nikkey2006]

Re: I have a MB model P67 Pro3

Hello my friend Emliy
Thanks friend for help me.

Well, I swapped the slots the memories blue, to white slot, pulled the VGA, I took the battery and a CMOS and now it is running fine again.

Strange it is that initially I had read on the website of Clube Do Hardware, which would have to install slots in white, but the system did not start, so when I put them in the blue slots, it worked.

Now they are in the white slots and everything is good.


Thanks my friend Emliy

[ASRock TSD - Emily]

Re: I have a MB model P67 Pro3

Dear Nikkey2006,

It's great to know your system works well.

If any problem in the future, please kindly let me know.

Thanks for your support!

Have a nice day
ASRock TSD Emily

[kick]

Re: I have a MB model P67 Pro3

Sometimes your asrock system D6 error may just be because you havent slapped the case before startup.

The system may want to have the last word.. continuously.

check this out.

YouTube - ‪sean connery on slapping women‬‏