I've got a N68C-S motherboard with two SATA HDD drives, one on SATA port 0.1 and the other on SATA port 0.0.
Both drives are recognised OK, BUT if both drives are fitted the system will only boot from port 0.1
If I want to boot port 0.0 I have to remove the drive connected to 0.1
If I press F11 and explicitly state I want the drive on port 0.0, it still boots from 0.1
Can anyone help me with this ?
Both drives are recognised OK, BUT if both drives are fitted the system will only boot from port 0.1
If I want to boot port 0.0 I have to remove the drive connected to 0.1
If I press F11 and explicitly state I want the drive on port 0.0, it still boots from 0.1
Can anyone help me with this ?
Comment