No announcement yet.
User Profile
Collapse
Profile Sidebar
Collapse
ZU476B72N4PC
Junior Member
Last Activity: 11-03-2021, 01:39 PM
Joined: 04-07-2021
Location: Antarctica
-
I have F8d for the GA-H97M-D3H rev 1.0 if that would be helpful. No idea if it's the same for rev 1.1, but just now I downloaded the F8b for rev 1.0 and 1.1 from the GIGABYTE site and confirmed the are the same/have the same checksum....
-
Does anyone have the links to the "e" beta bioses for the Z590 boards?
Leave a comment:
-
Install GPU-Z 2.40 and go to [Advanced/PCIe Resizable BAR] and let us know what it says....
Leave a comment:
-
Resizable BAR requires four things:
1. BIOS support - enable Above 4G Decoding then Resizable BAR
2. NVIDIA drivers from late March or later
3. RTX 3000 series card
4. GPU VBIOS update if your card is 3060 Ti or higher manufactured before April. All 3060 non-Ti are compatible...
Leave a comment:
-
Among other things, widespread reports that new version of EasyTune should be called EasyImmediateBlueScreen. Avoid the update until that issue is fixed, and if you already have it consider not using or uninstalling EasyTune....
Leave a comment:
-
-
This LAN issue seems to happen on different BIOS versions on different Gigabyte Z590 boards with the Intel I225-V (even though it's stepping 3 and they're supposed to have fixed all issues with this chip). See discussion here: https://forum.gigabyte.us/thread/12024/lan-issue...
Leave a comment:
-
I finally managed to resolve something very similar to this by disabling PCI Express Link State Power Management in my Windows power plan advanced settings.
...
Leave a comment:
-
I'm also having an issue with all versions of Z590 AORUS PRO AX that once a BIOS update is complete, the Intel I225-V ethernet device stops working (control panel error This device cannot start (Code 10)). This happens even if I Load Optimized Defaults both before and after the BIOS update.
...
Leave a comment:
-
Which board are you using? I've seen you post about the AORUS PRO AX and TACHYON.
If using the PRO AX, did you see the posts from me and zmeul? Using either of the middle two NVME slots will downgrade your GPU to x8 per the block diagram in the manual. You won't be able to use the top slot...
Leave a comment:
No activity results to display
Show More
Leave a comment: