Z590 Vision G - Unable to setup manually Ram Gear with 3600 RAM

[drapos]

Hi,

I'm having several issues when trying to use RAM abovee 3200mhz on this board. Tried 2 different sets of G.Skill Trident Z with Hynix chips.

One refused to boot above 3200 on Gear 1, 3600 was only possible on G2.

Then, the next one boots on Gear 1 @3600, but only with Gear settings on auto. Selecting manually 1 or 2 will result on no boot.

Also, trying to change RAM settings from auto, will result most of the times on no boot and force to reset to default and introduce manually old settings again. Reverting back changes manually will not fix it.

Is there any hope of updated BIOS fixing this?

Thanks and kind regards.

[drapos]

Realized that the issue is that the board will refuse most changes on first boot attempt.

The workaround is just to perform changes > Fails to boot > Enter Bios when prompted to do so > Exit and save changes without changing anything> Boot.