HELLO I have the following
Gigabyte EX58-UD5 rev1
Cpu i7 970, 3.20GHZ/ 12M/4.80/08
SLBVF 3031A794
Video MSI ARMOR RADEON RX 570 8GB GDDR5
RAM Crucial CT51272BA1067 2sticks 4GB each 512MX72 DDR3
PSU THERMALTAKE TOUGHPOWER PS-TDP 1,000 watt 80plus
hard drive Crucial BX500 120GB 3D NAND SATA SSD
Now that's over, my problem is it wont post, monitor gets no signal. No beeps. the led code number was 68 (PM Init). Not knowing I checked ram installed properly by removing and re-installing. Same result. Next I inspected cpu. Just to see it too installed right. Everything here looked good, clean off old paste, applied new paste. reinstalled coolmaster . NOW what it does when I plug in and turn on, all the fans spin (2 on video card, one in front of case, one on top of PSU, and the cool master fan) Just when fans begin it shuts down, off for 2-3 seconds then turns back on by itself, then shuts down again. It keeps repeating on-off-on-off until I pull the plug. This behavior started AFTER I removed and reinstalled those parts. Before it would just run, no beeps, and no signal to monitor. The 68 code I was getting was before I started my troubleshooting. This is a new build, all new parts and Im sick over it.
Gigabyte EX58-UD5 rev1
Cpu i7 970, 3.20GHZ/ 12M/4.80/08
SLBVF 3031A794
Video MSI ARMOR RADEON RX 570 8GB GDDR5
RAM Crucial CT51272BA1067 2sticks 4GB each 512MX72 DDR3
PSU THERMALTAKE TOUGHPOWER PS-TDP 1,000 watt 80plus
hard drive Crucial BX500 120GB 3D NAND SATA SSD
Now that's over, my problem is it wont post, monitor gets no signal. No beeps. the led code number was 68 (PM Init). Not knowing I checked ram installed properly by removing and re-installing. Same result. Next I inspected cpu. Just to see it too installed right. Everything here looked good, clean off old paste, applied new paste. reinstalled coolmaster . NOW what it does when I plug in and turn on, all the fans spin (2 on video card, one in front of case, one on top of PSU, and the cool master fan) Just when fans begin it shuts down, off for 2-3 seconds then turns back on by itself, then shuts down again. It keeps repeating on-off-on-off until I pull the plug. This behavior started AFTER I removed and reinstalled those parts. Before it would just run, no beeps, and no signal to monitor. The 68 code I was getting was before I started my troubleshooting. This is a new build, all new parts and Im sick over it.
Comment