I'm using the above board with the F10 BIOS (applied in the correct method, flash, applied optimised settings, save, restart, change settings to personal preference).
What I'm finding is that attempting to use C4E results in the following logged in Windows:
Idle power management features on processor 0 are disabled due to a firmware problem. Check with the computer manufacturer for updated firmware.
Idle power management features on processor 1 are disabled due to a firmware problem. Check with the computer manufacturer for updated firmware.
Using C2E works fine. However, I have an Intel E8600 (Wolfdale 45nm 3.33Ghz) which supports C4E mode (65nm did not). Anyone else experienced this problem?
I've logged a ticket with Gigabyte though I'm not hopeful of a fix.
What I'm finding is that attempting to use C4E results in the following logged in Windows:
Idle power management features on processor 0 are disabled due to a firmware problem. Check with the computer manufacturer for updated firmware.
Idle power management features on processor 1 are disabled due to a firmware problem. Check with the computer manufacturer for updated firmware.
Using C2E works fine. However, I have an Intel E8600 (Wolfdale 45nm 3.33Ghz) which supports C4E mode (65nm did not). Anyone else experienced this problem?
I've logged a ticket with Gigabyte though I'm not hopeful of a fix.
Comment