Hello all,
Well, thanks to Lsdmeasap for article on how to flash...i just did it and it was a pleasureable experience!
However, just after it performed the flash..these messages arose..
checksum 0300
are you sure to update Bios?
i replied yes. and a further message arose saying "copy bios completed - pass"
But is that checksum message something of concern?
Also,
under PC HEALTH STATUS of CMOS setup pages, i have..
vcore 1.204v
ddr18v 1.888v
+3.3v 3.296v
+12v 11.858v
current sys temp = 41 c
current cpu temp = 33-34 c
cpu fan = 936 rpm
(i only have 1 case fan which sucks air out)
cpu warning temp = Disables
cpu fan fail warning = Dis
cpu smart fan control = auto
Is there any issues here i should address?
cheers
Kurnell
Well, thanks to Lsdmeasap for article on how to flash...i just did it and it was a pleasureable experience!
However, just after it performed the flash..these messages arose..
checksum 0300
are you sure to update Bios?
i replied yes. and a further message arose saying "copy bios completed - pass"
But is that checksum message something of concern?
Also,
under PC HEALTH STATUS of CMOS setup pages, i have..
vcore 1.204v
ddr18v 1.888v
+3.3v 3.296v
+12v 11.858v
current sys temp = 41 c
current cpu temp = 33-34 c
cpu fan = 936 rpm
(i only have 1 case fan which sucks air out)
cpu warning temp = Disables
cpu fan fail warning = Dis
cpu smart fan control = auto
Is there any issues here i should address?
cheers
Kurnell
Comment