If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
i update from f12 20.12.31 to f12 21.1.18 and I get new cb r20 records (m=6102 & s=623) with my stored ram oc setting with default pbo. :)
so i'm very exited what will bring agesa 1.9.0 or the upcoming 2.0.0
updated to F60f, XMP profile 1 3200mhz for my RAM still not working, cold boot (was working perfectly fine with F50 and R5 3600) had to put and raise timings manually from CL 16-18-18 to CL 18-22-22 to make it post on cold at 3200 mhz
F32 on Aorus X570 Xtreme has worse USB problems than with any prior versions. USB2 or 3.
I have to unplug and plug back my APC UPS or else the connection will be unstable.
The new F12 BIOS' description is literally just the F11 description. To the outsider it looks like you just have the same BIOS but you changed the name and date on the page and nothing else. It is even the same AGESA version (1100 D) while I was under the impression that F12 is either AGESA 1.1.9.0 or 1.2.0.0?
stasio any idea if 1.1.9.0 stable will come first, or does it look like GB is skipping 1.1.9.0 and going to 1.2.0.0 for next stable release after 1.1.0.0 for most motherboard models?
hello! i have z390 aorus master with f11mgk bios! i try to update to f11n bios but i have oemid mismatch ! what can i do? second bios also upgraded to f11mgk !
i have this mistake also if i try update to f11m / f11l !
hello! i have z390 aorus master with f11mgk bios! i try to update to f11n bios but i have oemid mismatch ! what can i do? second bios also upgraded to f11mgk !
i have this mistake also if i try update to f11m / f11l !
Still huge issues with USB ports: with C-State enabled any external powered 3.0 USB Hub ceases to function after a couple of minutes and the system requires a full power down for the HUB to work again. Any peripheral that requires full USB 3.x specs/power (as the HP Reverb G2 VR headset) will not even power up with most of the USB ports in the Motherboard and the only two (in my case) on which it actually starts create continuous disconnects and are practically unusable.
I hope this huge issue gets fixed soon. I don't know if it is a problem specifically of Gigabyte or AMD in general but to even have USB peripherals work correctly I have to attach them to the USB ports in my case or to an external HUB (and even in the latter case there are still issues with C-States powering the latter down).
Comment