If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have just tested X570 AORUS Master - F31h for 2 hours on a 5900x.
Maximum POST fclk increased from 1900 to 2000, but this is horribly unstable. Constant WHEA error. I got about 500 WHEA error during testing and had to repair my OS several times, in the end i was only able to stop them by dropping FCLK to 1600.
Next i will test the boost curve stuff, but since stable FCLK dropped by 267mhz since last bios i will have to revert for my daily system after that.
Are you guys stability testing and checking for WHEA errors? I can also take a screenshot of IF 2000 but it corrupted my OS in minutes even down at 1867. If that's happening for you, it will cause problems very fast - if it's not, that would be good information to post.
I'm running through boost curve offsets at 1600 IF at the moment and that's been amazing so far. Multiple workloads sped up by 4% and sustained effective clocks far higher without any sign of instability yet!
Hi, Thanks,
Any Changelog ? I'm experiencing issue with the pro (USB 2.0 freeze when using PCie Gen 4) and a friend with a b550i Pro AX the USB dont power up a Valve index.
Is gigabyte having a lot of issue with usb ?
A lot of feedback about USB here : https://www.reddit.com/r/Amd/comment...otherboard_if/
Hi, Thanks,
Any Changelog ? I'm experiencing issue with the pro (USB 2.0 freeze when using PCie Gen 4) and a friend with a b550i Pro AX the USB dont power up a Valve index.
Is gigabyte having a lot of issue with usb ?
A lot of feedback about USB here : https://www.reddit.com/r/Amd/comment...otherboard_if/
I'm also getting tons of WHEA errors on F31g and F31h if I try to run my memory at anything higher than 3600CL16 on my x570 Aorus Master with a 5900x. I have no issues running the same config on bios F31e at 3800CL16 or 3800 CL14.
Hi, Thanks,
Any Changelog ? I'm experiencing issue with the pro (USB 2.0 freeze when using PCie Gen 4) and a friend with a b550i Pro AX the USB dont power up a Valve index.
Is gigabyte having a lot of issue with usb ?
A lot of feedback about USB here : https://www.reddit.com/r/Amd/comment...otherboard_if/
try disabling/uninstalling rgb fusion (wipe EVERYTHING rgb fusion). it's real mess with ram and causes bios reset
Are you guys stability testing and checking for WHEA errors? I can also take a screenshot of IF 2000 but it corrupted my OS in minutes even down at 1867. If that's happening for you, it will cause problems very fast - if it's not, that would be good information to post.
I'm running through boost curve offsets at 1600 IF at the moment and that's been amazing so far. Multiple workloads sped up by 4% and sustained effective clocks far higher without any sign of instability yet!
I have not yet done any stability testing, I just did a quick and dirty will it boot at 2000 fclk before going to bed.
Anyone kind enough to explain me how does "Enhance Curve Optimizer" work ?
Long time overclock with intel but back on AMD after 15years, so ... the climb is hard ^^
Comment