If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Loving this new F11IGK with RGB Fusion i was having temp issues until i told them about the vcore bug returning. now i don't see temps higher than 60c under load with my 9900K
It restores the missing "Core Current Limit(Amps)", "CPU Vcore/VAXG Protection", "CPU Core PLL Overvoltage(+mv)" settings and fixes the broken "Turbo Per Core Limit Control" setting. It also updates the microcode to DE.
Flashed and all seems well.
Great that the board still gets updates, well done Gigabyte.
thanks Stasio for Z390 Aorus Master BIOS F11m posted.
Tried the latest version F11M thanks a lot, it seems to work fine I will run further tests! But what about the version with F11L gk with integrated rgb fusion has anyone tested it? If I install the F11L gk version is it possible to revert to the non-gk version?
Hence it's a ZEN3 CPU I tried the only available F11d.
But there's something:
I tried then 16GB RAM of Aegis modules 3000 MHz (2x8gb G.Skill F4-300C16D-16GISB) fro my old setup.
I put in RAM slot A2 and B2 each 8GB as recommended in the manual.
Could successfully manage to activate the XMP Profile for those AEGIS running at 3000MHz.
Shutdown the system, changed both AEGIS modules for TridentZ modules, which then also ran with 3000MHz.
I went them back to the BIOS deactivated and reactivated XMP.
Booted the system and got the TridentZ (G.Skill F4-4400C19D-16GTZSW)
Comment