Tweet
Hi,
I have a C2750d4i in my Freenas box, and it won't boot. I have the JViewer window open and it's entirely blank. It's been working for over a year up until now and I'm at a loss right now.
It powers on, fans start etc, then about 2-4 seconds in it shuts back down. I've tried disconnecting all power rails except the motherboard, no change. In the IPMI my CPU temp shows to be -115. (yes, negative). I can't think of anything else that stands out at the moment.
Any advice?
Edit:
In looking through the logs via IPMI, I found this:
122 Feb 22 17:51:29 AMIBC5FF4FE5A26 kernel: ERROR: I2C1: BUS recovery did not succeed
123 Feb 22 17:51:29 AMIBC5FF4FE5A26 kernel: I2C1: Master-Xfer failed. Bus busy
I have a C2750d4i in my Freenas box, and it won't boot. I have the JViewer window open and it's entirely blank. It's been working for over a year up until now and I'm at a loss right now.
It powers on, fans start etc, then about 2-4 seconds in it shuts back down. I've tried disconnecting all power rails except the motherboard, no change. In the IPMI my CPU temp shows to be -115. (yes, negative). I can't think of anything else that stands out at the moment.
Any advice?
Edit:
In looking through the logs via IPMI, I found this:
122 Feb 22 17:51:29 AMIBC5FF4FE5A26 kernel: ERROR: I2C1: BUS recovery did not succeed
123 Feb 22 17:51:29 AMIBC5FF4FE5A26 kernel: I2C1: Master-Xfer failed. Bus busy