Can anybody help.
I have N68-S motherboard (AMD2+;DDR2).
ASRock > Products > N68-S
In BIOS (F2 key) I can't change CPU voltage; CPU multipler and most important NorthBridge multipler!
If I change option from auto to manual - my PC don't want to startup, even if I enter the same NB & CPU multiplers and CPU voltage settings what used by default.
To start my PC after that I need to clear CMOS, or pray for "Boot Failure Guard" to use default settings (after resetting/powerON-OFF many times).
I have tried BIOS versions 1.6 and 2.1 - both version has the same problem.
PS: I try to tune other options a little (somethere I read what NB frequency must be higher than HT freq). I tryed to reduce HT to minimum (200 MHz) - but have the same result.
I have N68-S motherboard (AMD2+;DDR2).
ASRock > Products > N68-S
In BIOS (F2 key) I can't change CPU voltage; CPU multipler and most important NorthBridge multipler!
If I change option from auto to manual - my PC don't want to startup, even if I enter the same NB & CPU multiplers and CPU voltage settings what used by default.
To start my PC after that I need to clear CMOS, or pray for "Boot Failure Guard" to use default settings (after resetting/powerON-OFF many times).
I have tried BIOS versions 1.6 and 2.1 - both version has the same problem.
PS: I try to tune other options a little (somethere I read what NB frequency must be higher than HT freq). I tryed to reduce HT to minimum (200 MHz) - but have the same result.